blank

Plug & Play/ MVP series

+ Linear guide way
+ Z-axis servo motor coupled directly to ball screw
+ Eco-friendly design.

Z-axis servo motor coupled directly to ball screw
No more Z-axis timing belt, the servo is connected to the ball screw. There is no more need to maintain or replace the timing belt.
Z-axis servo motor upgraded and no counter-balance block (opt.)
Special package to improve the precision of Z-axis movement in high speed machining.
1100mm (MVP8/10) wide column case. The column on the MVP features a heavier structure than competing models to upgraded stability. The column and base are oversized fully ribbed support heavy loads without table deflection.
Drain through built-in on working table.
Incorporated oil fluid separation on casting design.
Eco-friendly design.
1600mm oversized base
One piece Meehanite casting which is stable, rigid and rugged. To ensure maximum rigidity, the MVP-8 and MVP-10 are built on heavy duty Meehanite casting. Also, all axes are reinforced to provide upper most rigidity and stability.
φ50 ball screws on 3 axes(MVP-13)
All balls crews are center mounted and supported on both ends by high precision angular contact thrust bearing. All servo motors with absolute encoders for increasing efficiency and dependability. (FANUC and Mitsubishi only)

MODEL	MVP-8	MVP-10	MVP-11	MVP-13	MVP-16
Table Size (mm)	1000×560	1150×560	1270×600	1400×700	1750×820
Max. table load (kg)	500	700	1000	1500	2000
X Axis Travel (mm)	860	1050	1100	1300	1600
Y Axis Travel (mm)	530	530	600	700	820
Z Axis Travel (mm)	630	630	630	650	700
Spindle nose taper	#40
Spidnle speed(Pulley) (rpm)	8000 opt.10000/12000
Spindle speed(DDS)(rpm)	opt.10000/12000/20000
Slideways	Linear guide way
Controller	Fanuc Oi-MF / Mitsubishi M80A
Rapid traverse rate(X/Y/Z) (m/min)	36/36/30 opt.48/48/36
Tool storage (pcs)	A:24 opt. S:16